مميزات المنتج

• 1.Class D amplifier: The cool running,low-profile,high efficiency design makes the perfect choice for even the most space-conscious system designs;
• 2.Dante interface: Receiving digital signal from Dante network,and convert to analog audio signal to the amplifier;
• 3.Analog audio inputs;
• 4.150W per channel: A powerful output are available to provide ample power to even the largest of spaces;
• 5.Trigger in/out:Amplifier can be activated by a 12V DC trigger signal,and can activate additional devices at the same time;
• 6.Multiple Turn-on modes:
  ①Always On: Amplifier is always active and ready for use;
  ②Signal-sensing: Amplifier is in a standby mode when no audio signal is present and will turn on when an audio signal is detected;
  ③Remote control: The amplifier can be turned on or off precisely when needed, so that the device is in power saving standby mode when not in use
• 7.Multiple Output modes:
  ①8Ω-optimized mode for 8Ω stereo output;
  ②4Ω-optimized mode for 4Ω stereo output;
  ③Bridged mode-300W output for 70V or 100V (Direct Drive).
• 8.Switch for High Pass Filter;
• 9.Removable speaker connectors:Allow for quick,secure installation and accommodate cables of up to 12 ga AWG;
• 10.Thermal Protection:
  ①All amplifiers are designed with special circuitry to safeguard the Amplifier under a thermal overload condition.Thermal protection mode can only engage when the unit has been run at high volume for extended periods of time without adequate ventilation and/or when speaker impedance are below the minimum levels for the amplifier.If this fault occurs,turnoff the amplifier,and check that the speaker impedance rating is above the minimum rating.Also check for adequate ventilation around the amplifier and make adjustments if necessary.Once the unit has cooled to safe operating temperatures,the amplifier may be powered back on.
• 11.Protection Circuitry:
  ①All amplifiers are designed with special circuitry to safeguard the amplifier under a short-circuit condition.A faulty speaker can also cause a short circuit condition.The front panel LED illuminates orange when the amplifier is in short circuit protection.If this fault condition occurs,turn off the amplifier and check speakers for short circuit conditions when appropriate.